’96 R1100GS Project Gas Tank Restoration

Intro with some pics here https://forums.bmwmoa.org/threads/fell-off-the-wagon.111295/#post-1386909So, need to restore the tank. Meaning, strip out the old tank coating that’s falling apart, prep and re-coat.

First, I wanted to figure out a good way to seal the tank during the process, since sloshing stuff around the tank is required, and then letting it sit, etc.. Decided to use the old o-rings which are all cracked up anyway, and make plates for the openings, and just use existing screws. Had some 24ga stainless for the pump opening and used some sheet metal to make a plate which goes over the nozzle fill hole.

In order to use the stock screws on the filler hole I just flip the filler neck over (the sheet metal plate I made is kind of thin, the neck adds rigidity) and put the filler cap over that as the spacer. Looks great, doesn’t it? :ROFLMAO:

So, I’ve decided on a KBS re-coat kit, 12 gallon size. I’m wondering if even that’s going to be enough. That 6.6 gallon tank has a lot of surface area.

First step is stripping out the old coating. At least 90% of that tank I can’t see, so have to assume if what I do see looks good, the rest does (no I don’t have a bore scope). I was debating about using Acetone vs KBS stripper. I decided to just try a gallon of acetone first and see what happens. Sealed off the pump opening, threw in a three foot length of 1″ link chain, a handful of washers and bolt, dumped a gallon of acetone, sealed up the top and went to town shaking and flipping. Man that tank is awkward…

The nice thing about the plates for sealing is pressure builds up during the process, so I can loosen the top screws until I hear pressure start to release, leave it like that, and shake and scrape the bottom, or do the same on the bottom to shake and scrape the top sections.

At this point I’m letting the tank sit upside down, in a shed far from the house, so that the top of the tank, which still has a lot of coating in tact, gets properly soaked. I’ll check it tomorrow. The fumes should do some work on the rest of the tank.

I’ve watched a lot of YouTube videos on redoing tanks. They all have one thing in common… it’s some simple classic tank with an elevated gas cap, so you can just pour stuff in and pour it out, easy peasy. Not going to work here… The gas cap and filler are recessed, which means there’s about a 1/2-3/4″ lip protruding into the tank, and so I’ll have do a lot of sloshing around when I’m emptying, and I’ll probably still have some stuff/fluid/whatever stuck in there. During the rinsing I’ll have to try and wash it all to the pump opening, which also has a lip, but I can get in there and wipe out anything remaining.

Anyone have any experience with stripping out an old tank with Acetone or KBS Strip?
IMG_20261112_103141_743.jpg
IMG_20261109_111911_825.jpg
Yeah, nice strainer, huh? That filler neck is toast too, as are all the related hoses… Have you seen the price of hoses from BMW? :oops: I’m guessing some pressurized fuel line from the auto parts store will do that job.

You can’t see in the tank because there’s a black plate under that filler.
IMG_20261112_103159_257.jpg

Leave a Reply